Touchpad - HP ENVY x360 Series Maintenance And Service Manual

TouchPad

NOTE: The TouchPad spare part kit does not include the TouchPad cable. The TouchPad cable is available using
spare part number L53534-001.
NOTE: The TouchPad spare part includes rubber padding.
Table 5-5 TouchPad description and spare part number information
Description
TouchPad (includes TouchPad bracket)
Before removing the TouchPad, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the system board.
2. Remove the four Phillips M2.0×2.9 screws (2) that secure the TouchPad and bracket to the keyboard/
top cover.
3. Remove the TouchPad bracket (3).
4. Remove the three Phillips M2.0×2.3 broad head screws (4) that secure the TouchPad to the keyboard/
top cover.
36 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 30).
28).
Spare part number
L53699-001