4.
Remove the fingerprint reader module (4) and cable.
Reverse this procedure to install the fingerprint reader module.
Fingerprint reader module cable
NOTE:
The fingerprint reader module cable is available using spare part number L53536-001.
Before removing the fingerprint reader module cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the fingerprint reader module cable:
1.
Release the zero insertion force connector (1) to which fingerprint reader module cable is connected,
and then disconnect the fingerprint reader module cable from the fingerprint reader module.
Bottom cover on page
Battery on page
30).
28).
Component replacement procedures
41