Volume Button Board And Cable - HP ENVY x2 12 Maintenance And Service Manual

Volume button board and cable

Description
Volume button board (includes Mylar screw/POGO cover)
Volume button board bracket (includes Mylar screw/POGO cover)
Before removing the volume button board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
5. Remove the Mylar shield (see
6. Disconnect the battery cable from the system board (see
Remove the volume button board:
1. Release the ZIF connector (1) to which the volume button board cable is connected, and then disconnect
the volume button board cable from the system board (2).
2. Remove the Phillips PM2.0×2.0 screw (3) that secures the volume button board to the tablet.
3. Remove the volume button board (4).
Reverse this procedure to install the volume button board.
Display assembly on page
Mylar shield (WWAN models only) on page
Spare part number
L14760-001
L14761-001
32).
37).
Battery on page 40).
Component replacement procedures 51