Power Button Board - HP ENVY x360 Series Maintenance And Service Manual

Power button board

NOTE: The power button board spare part kit does not include the power button board cable. The power
button board cable is available using spare part number L53533-001.
Table 5-10 Power button board description and spare part number information
Description
Power button board
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the power button board:
1. Release the ZIF connector (1) to which the power button board cable is connected, and then disconnect
the power button board cable from the system board.
2. Remove the two Phillips M2.0×2.9 screws (2) that secure the power button board to the keyboard/
top cover.
3. Remove the power button board (3).
Reverse this procedure to install the power button board and cable.
48 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 30).
28).
Spare part number
L53869-001