Fingerprint Reader Module - HP ENVY x360 Series Maintenance And Service Manual

Fingerprint reader module

NOTE: The fingerprint reader module spare part kit includes the bracket but does not include the fingerprint
reader module cable. The fingerprint reader module cable is available using spare part number L53536-001.
Table 5-7 Fingerprint reader module description and spare part number information
Description
In natural silver finish
In natural silver finish with wood grain
In night fall black finish with wood grain
Before removing the fingerprint reader module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader module:
1. Release the ZIF connector (1) to which the fingerprint reader module cable is connected, and then
disconnect the fingerprint reader module cable from the switch board.
2. Remove the Phillips M2.0×2.3 broad head screw (2) that secures the fingerprint reader module and bracket
to the keyboard/top cover.
3. Remove the fingerprint reader module bracket (3).
40 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 30).
28).
Spare part number
L52651-001
L52652-001
L53480-001