Power Button Board Cable - HP Stream x360 Maintenance And Service Manual

Power button board cable

Description
Power button board cable
Before removing the power button board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the power button board cable:
1. Remove the four Phillips PM2.5×6.3 screws (1) that secure the display left hinge to the keyboard/
top cover.
2. Swing the display left hinge up and back until the power button board cable is accessible (2).
3. Release the ZIF connector (1) to which the power button board cable is connected, and then disconnect
the power button board cable from the system board.
4. Release the ZIF connector (2) to which the power button board cable is connected, and then disconnect
the power button board cable from the power button board.
5. Detach the power button board cable (3) from the keyboard/top cover. (The power button board cable is
attached to the keyboard/top cover with double-sided adhesive.)
Bottom cover on page 28).
Spare part number
906777-001
Battery on page 30).
Component replacement procedures 43