Agilent Technologies InfinityLab LC Series User Manual page 190

13 LAN Configuration
Dynamic Host Configuration Protocol (DHCP)
2 Set the Configuration Switch to DHCP either on the G1369C LAN Interface
Table 19
SW 4
ON
Table 20
SW 6
ON
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition, Lab
Agilent InfinityLab LC Series RID User Manual
Card or the main board of above mentioned modules.
G1369C LAN Interface Card (configuration switch on the card)
SW 5 SW 6
OFF OFF
LC Modules with 8-bit configuration switch (B-firmware) (configuration switch at rear
of the instrument)
SW 7 SW 8
OFF OFF
Advisor, Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note in
section "General Information (DHCP)"
SW 7 SW 8 Initialization Mode
OFF OFF DHCP
Initialization Mode
DHCP
on page 188).
190