Setting Up The Flexible Cube With Agilent Chemstation - Agilent Technologies 1290 Infinity User Manual

5
Using the Module

Setting up the Flexible Cube with Agilent ChemStation

Setting up the Flexible Cube with Agilent ChemStation

The setup of the Flexible Cube is shown with the Agilent ChemStation B.04.02
SP1. Depending on the controller (e.g. Agilent Instant Pilot, EZChrom Elite)
the screens look different.
This section describes the Flexible Cube settings only. For information on the Agilent
N O T E
ChemStation or other 1290 Infinity modules refer to the corresponding documentation or
the 1290 Infinity System Manual.
After successful load of the ChemStation, you should see the module as an
active item in the graphical user interface for the Autosampler (GUI).
Figure 15
54
ChemStation Method & Run Control
1290 Infinity Flexible Cube User Manual