Table of Contents
Advertisement
To prevent unauthorized use and damage, properly stow
the aerial platform at the end of each work day. It must
also be properly stowed while transporting.
Stowing
Use the following procedure to properly stow the aerial
platform.
Caution
The extension deck is free to move when the extension
handle locks are disengaged. Personal injury may
result from accidentally extending or retracting the
deck. Make certain both extension handle locks are
fully engaged when the deck is extended in the work-
ing position and when it is stowed. Do not attempt to
extend or retract the platform unless the aerial platform
is on a level surface.
1. Fully retract the platform extension deck and ensure
that it is secured in position, with the latch handles
fully lowered and the locks fully engaged.
2. Fully lower the platform.
3. Push the emergency stop button inward on the lower
control panel.
4. Turn the battery disconnect switch off and lock it.
5. Securely close the swing-out trays.
Transporting
The aerial platform may be moved on a transport vehicle.
Depending on the particular situation, the aerial platform
may be lifted with a forklift, driven, winched, or hoisted
onto a vehicle such as a truck or trailer. Lifting with a
forklift is the preferred method.
The equipment used to load, unload, and transport the
aerial platform must have adequate capacity. The empty
vehicle weight is listed in Chapter 2 and is stamped on
the serial number placard.
The user assumes all responsibility for:
Choosing the proper method of transportation.
y
Choosing the proper selection and use of transporta-
y
tion and tie-down devices.
Making sure the equipment used is capable of sup-
y
porting the weight of the aerial platform.
Making sure all manufacturer's instructions and warn-
y
ings, regulations and safety rules of their employer,
the DOT, and/or any other state or federal law are
followed.
S3215L/S3215E/S3219E/S3220E/S3226E/S4726E/S4732E – 1500834
Chapter 10 – Stowing and Transporting
Lifting With a Forklift
Use the following procedure to lift the aerial platform with
a forklift.
1. Properly stow the aerial platform.
2. Remove all personnel, tools, materials, or other loose
objects from the platform.
3. Insert the forklift forks into the pockets at the rear of
the machine (refer to Figure 10.1).
Forklift Pockets
Figure 10.1 – Rear of Chassis
4. Do not raise the aerial platform higher than necessary
to transport it. Drive the forklift slowly and carefully
when transporting the aerial platform.
Winching
Use a winch to load and unload the aerial platform on
ramps that exceed the machine gradeability specification.
A winch may also be used when poor traction, uneven sur-
faces, or stepped ramp transition make driving hazardous.
Use the following procedure to winch the aerial platform
onto the transport vehicle.
1. Position the transport vehicle so the aerial platform
will not roll forward after it is loaded.
2. Remove any unnecessary tools, materials, or other
loose objects from the platform.
3. Drive the machine to the foot of the loading ramp
with the front wheels nearest the ramp. Make sure
the machine is centered with the ramps and that the
steering wheels are straight.
4. Properly stow the aerial platform.
Warning
The aerial platform is free to move when the brakes
are released. Death or serious injury can result.
Re-enable the brakes before operating the aerial
platform.
47
Hide quick links:
Advertisement
Table of Contents
