Snorkel S3215L Operator's Manual page 41

0361259
1501533
1501475
1502773 – S3215L
1502777 – S3215E
1502598 – S3219E
1502777 – S3220E
1502774 – S3226E
1502775 – S4726E
1502776 – S4732E
S3215L/S3215E/S3219E/S3220E/S3226E/S4726E/S4732E – 1500834
300760
451986
(Behind tray)
Right Side
1501476
Rear
Chapter 8 – Prestart Inspection
Proper position for safety prop use
Death or serious injury
might result if safety prop
is not used and/or
properly positioned. Use
safety prop at all times
when servicing machine
with platform raised.
0361259
WARNING
DEATH OR SERIOUS INJURY COULD RESULT
FROM UNCONTROLLED MOTION.
Towing this machine requires disengaging the brakes. Follow instruction
below when towing, pushing, or winching this machine. Verify the brakes
have been reset after moving machine and before operating the machine.
TOWING INSTRUCTIONS
1. Before towing, pushing, or winching, the machine must be on level
ground. Read and understand all instructions. Refer to the Operator's
Manual. Turn battery disconnect switch to "OFF" position.
2. Turn the brake release valve clockwise to the fully closed position.
3. Turn the free-wheeling
valve counterclockwise to
the fully open position.
4. Push and release the brake
release pump several times
to release the brakes.
5. DO NOT exceed 2 mph
(3.2 km/h) when towing.
6. After moving the machine,
turn the brake release valve
fully counterclockwise.
Turn the free-wheeling valve
fully clockwise. Operate
the drive function to verify
that the brakes reset.
1501533
DANGER
TIPOVER HAZARD
DEATH OR SERIOUS INJURY MAY
RESULT IF MACHINE TIPS OVER
T rays must be closed when platform is elevated.
300760
DANGER
DO NOT ALTER OR DISABLE
LIMIT SWITCHES, SAFETY
SWITCHES, OR INTERLOCKS.
451986
DEATH OR SERIOUS INJURY WILL RESULT FROM
TIPPING OVER. TO KEEP FROM TIPPING THIS
MACHINE OVER FOLLOW THESE RULES.
DO NO T RAISE OR DRIVE AN ELEV A TED
PLA TFORM ON A SLOPE
GO NO CLOSER THAN
4 FEET (1.2 M) to
ANY DROP OFF
OR HOLE
4 FT
OTHER ACTIONS CAN ALSO CAUSE
THIS MACHINE TO TIP OVER
DO NOT override safety devices.
DO NOT overload the machine.
DO NOT stand or sit on guardrails.
DO NOT attach ropes or chains to guardrails.
DO NOT carry loads outside the railing or use as a crane.
ALARM MEANS TIPO VER DANGER!
LOWER PLA TFORM IMMEDIA TEL Y
1. 2. 3.
OK
ELECTRICAL SHOCK CAN KILL YOU
This machine is not electrically insulated.
Maintain 10 feet (3.1 m) minimum clearance
from electrical power lines and apparatus.
This machine will not protect you from shock.
DO NOT use this machine without the railings and the
entry gate, chain or bar in place. Y ou could fall
out and hurt or kill yourself.
DO NOT use this machine if it is not working right, or if
any part of it is damaged, worn, or missing.
An accident could cause injury or death.
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
1501475
1501475
MODEL MAXIMUM
PLATFORM
NUMBER
HEIGHT
MONTH / YEAR
OF MANUFACTURE
RATED NUMBER
OF OCCUPANTS
EMPTY
lbs
VEHICLE
kg
WEIGHT MAXIMUM
DRIVE
MAXIMUM
HEIGHT
GRADEABILITY
UNRESTRICTED
MAXIMUM Indoors Outdoors PLATFORM
ALLOWABLE CAPACITY
lbs
MANUAL FORCE MAXIMUM
N
(SIDE PULL)
ALLOWABLE
WIND SPEED
Do not remove any weight from this machine.
1502773/1502777/1502598/1502774/1502775/1502776
PROPER USE OF SAFETY PROP
1. Remove all material from platform.
2. Raise platform until the open height is wide
enough to position the safety prop.
3. Place safety prop in the proper position.
4. Remove hands and arms from scissors area.
5. Lower platform until scissors are supported by
safety prop.
TO STORE SAFETY PROP
1. Raise platform until the open height is wide
enough to position the safety prop.
2. Place the safety prop in the storage position.
0361259
DISENGAGE BRAKES
DO NOT operate any hydraulic functions
after disengaging the brakes or the brakes
will reset, preventing the machine from
being moved.
Brake
Release
Pump
Brake
Release
Valve
Free-Wheeling
Valve
HYDRAULIC
MANIFOLD VALVE
1501533
300760
451986
DEATH OR SERIOUS INJURY WILL RESULT FROM
TIPPING OVER. TO KEEP FROM TIPPING THIS
MACHINE OVER FOLLOW THESE RULES.
DO NO T RAISE OR DRIVE AN ELEV A TED
PLA TFORM ON
SOFT OR UNEVEN
SURFACES
DO NO T RAISE THE PLA TFORM
IN W IND ABO VE 28 MPH (12.5 M/S)
OTHER ACTIONS CAN ALSO CAUSE
THIS MACHINE TO TIP OVER
DO NOT ride platform while machine is on a truck, fork lift
or other device.
DO NOT use ladder, scaffold, or other means to increase
size or platform height.
DO NOT use with damaged tires or wheels.
OK
TO A VOID
TIPO VER HAZARDS
USE ON
FLA T, LEVEL, AND
SOLID SURFACES
ONL Y
4 FT
ELECTRICAL SHOCK CAN KILL YOU
Allow for platform sway, rock, or sag.
If voltage is 300 V to 50 kV , stay at least
10 feet (3.1m) away.
If voltage is more than 50 kV , talk with your
supervisor or read the Operator's Manual
on this machine for safe distances.
DO NOT let an untrained or unauthorized person use this
machine. When leaving the machine unattended,
remove the key, turn the battery disconnect switch
off, and lock it in the off position.
DO NOT replace components critical to machine stability,
such as batteries and wheels, with lighter weight
or non-factory approved substitutes.
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
1501476
1501476
Snorkel International
2009 Roseport Road
Elwood, KS 66024
SERIAL
NUMBER
SLOPE SENSOR ALARM SETTING
Indoors Outdoors
FRONT SIDE
deg
TO BACK TO SIDE
MAXIMUM
WHEEL
ft
LOAD
m
MOTOR
lbs
kg
BATTERIES
mph
CHARGER
m/s
INPUT
1501664
deg
lbs
kg
V
V
Ah
V
37