Chapter 4 – Safety Devices
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury will result from a tip-over
accident. Do not drive or position the aerial platform
for elevated use near any drop-off, hole, slope, soft
or uneven ground, or other tip-over hazard.
Completely lower the platform and drive to a level surface
when the tilt alarm sounds.
The tilt alarm is for added protection and does not justify op-
erating on anything other than firm, flat, level surfaces.
Horn
The horn may be used to warn personnel on the ground.
The horn is operational when the machine is set up for
operation from the upper controls.
The horn button is located on the front of the upper control
panel (refer to Figure 4.2).
Flashing Light
An optional amber flashing light may be located under
the upper control box. The flashing light warns personnel
that the aerial platform is in the area.
The light flashes at about one flash per second when the
machine is set up for operation from the upper controls.
18
S3215L/S3215E/S3219E/S3220E/S3226E/S4726E/S4732E – 1500834