SDC-CF10G
Hardware Integration Guide
M
S
ECHANICAL
PECIFICATIONS
Connector Overview
CF10G connector:
RF L
D
AYOUT
ESIGN
The following is a list of RF layout design guidelines and recommendation when installing a Summit radio into
your device.
Do not run antenna cables directly above or directly below the radio.
Do not place any parts or run any high speed digital lines below the radio.
If there are other radios or transmitters located on the device (such as a Bluetooth radio), place the
devices as far apart from each other as possible.
Ensure that there is the maximum allowable spacing separating the antenna connectors on the Summit
radio from the antenna. In addition, do not place antennas directly above or directly below the radio.
Summit recommends the use of a double shielded cable for the connection between the radio and the
antenna elements.
Summit has provided three plated mounting holes that can be used for grounding. When additional
ground plane is required, you may use some or all of these grounded mounting holes.
Mounting
Through-hole mounting with a 50-pin connector. Summit recommends non-metallic screws.
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
50-pin connector
G
UIDELINES
12
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610