Table of Contents
Advertisement
Ensure that the wiring distance from the
power supply is within the range shown
in the table on the right.
When using two or more units on one
wire, the maximum length is obtained by
dividing the wire length listed below by
the number of units used.
Connection using the connector
4
Connector
8-2
BACK COVER : BC-3
Cutout of the knockout
1
Back Cover
Cut with cutter.
Knockout
Cut off the knockout portion of the
back cover with a cutter, etc.
Fix the unit base body mounting-plate and the
pole bracket for the option supplied with the
back cover by using the supplied screws.
8-3
POLE SIDE COVER : PSC-3
Cutout of the knockout
1
Outside of the knockout ( 35-48mm : the diameter of a pole)
Inside of the knockout ( 32-34mm : the diameter of a pole)
Pole Side Cover
Cut only the
required parts
with cutter
Cut the edge of the knockout (outside or inside) with a
nipper and then break the knockout portion with a cutter.
Also break the center bridge of the pole side cover along
with the perforation.
Wiring distance
Wire Size
Wiring Distance
AWG18
300 m (1000 ft.)
(0.83mm
)
2
AWG16
500 m (1700 ft.)
(1.31mm
)
2
AWG14
800 m (2600 ft.)
(2.09mm
)
2
When connecting the lead wires to the
wiring, make the connection using the
supplied connector or soldering. Insert
the wires into the connector and tighten
the connections with pliers.
Installation of mounting plate
2
Mounting plate
lock screws
(for main unit)
Pole lock screws
(for main unit)
Note>>
Do not use pole bracket
supplied with the unit
Cut the perforation
with a cutter
EN-11
UL Listed applications, the heating unit
was not investigated with the models
AX-70/130/200TN, AX-100/200TF.
Mounting of the unit base and
5
optical alignment
Unit Base Mounting Screw
Installation of the unit base and the
3
back cover
Unit Base
Optional
pole bracket
(for BC-3)
Knockout
(The same applies to
the opposite side.)
After mounting the units base, fix the back
cover on the pole bracket by using the
screws (4 pieces).
Align the optical axis and check for the
operation, then close the cover.
(See "3. INSTALLATION")
Installation of the pole side covers
2
Mounting plate
lock screws
(for main unit)
Pole lock
screws
(for main unit)
Fix the unit base body mounting-plate and the pole bracket
for the option supplied with the pole side cover by using the
supplied screws.
Back cover lock
screw (The same
applies to the
opposite side.)
Note>>
Do not use pole
bracket supplied
with the unit
Optional pole bracket
(for PSC-3)
Hide quick links:
Advertisement
Table of Contents
