Aimer Delay; User-Specified Aimer Delay; Aimer Mode - Honeywell Vuquest 3320g User Manual

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the button is
pushed and when the picture is taken. During the delay time, the aiming light will
appear, but the LEDs won't turn On until the delay time is over. Default = Off.
200 milliseconds
* Off (no

User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming

Aimer Mode

This feature allows you to turn the aimer On and Off. When the Interlaced barcode
is scanned, the aimer is interlaced with the illumination LEDs. Default = Interlaced.
Off
50
Chart, beginning on page 222, then scan Save.
Delay Duration
Vuquest 3320g User Guide
400 milliseconds
* Interlaced