Aimer Delay; User-Specified Aimer Delay - Honeywell Voyager 1602g User Manual

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the
barcode is read. Use these codes to set the time between when the scan button is
pressed and when the barcode is read. During the delay time, the aiming light will
appear, but the LEDs won't turn on until the delay time is over. Default = Off.

User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart
80
* Lights On
200 milliseconds
* Off (no delay)
inside the back cover of this manual, then scan Save.
Delay Duration
Voyager 1602g User Guide
Lights Off
400 milliseconds