Advertisement
Firmware Updates
Download firmware updates from the Extron website and upload them via the internal web pages or PCS.
DTP2 CrossPoint 82 Configuration
To configure DTP2 CrossPoint 82, you can use the front panel controls, the internal web pages, PCS, SIS, or the on-screen
display (OSD) menu (DTP2 scaled output only).
On-screen Display (OSD) Menu System
NOTE:
The OSD is available only via the DTP2 scaled output.
Displays connected to the unscaled HDMI output cannot display
the OSD.
To configure DTP2 CrossPoint 82 using the OSD menu, connect a display
to a DTP2/XTP matrix switcher/HDBaseT compatible device. The OSD
menu consists of eight submenus accessed using the front panel Menu or
Enter button (see the example at right).
Extron Product Configuration Software
To configure DTP2 CrossPoint 82 switchers using PCS, install the
software (available at www.extron.com) to a PC connected to the
switcher via Ethernet or front panel USB Config port (see
page 1). After the installation, start the program. For full instructions, while
the program is running, press <F1> on the keyboard, click the ? button in
the software, or select the help file option from the device tab menu.
Internal Web Pages
To configure the DTP2 CrossPoint 82 using the factory-installed web pages in a web browser, connect the AV LAN connector
(IPCP models) or LAN connector (base model) to a LAN or WAN. The default IP address is 192.168.254.254. A password is
required the first time the page is opened and remains in effect until changed or removed.
NOTE:
The factory configured passwords for all accounts on this device have been set to the device serial number. In the
event of an absolute system reset, the passwords convert to no password. Passwords are case sensitive.
Basic SIS Command Table
To configure the DTP2 CrossPoint 82 with specific SIS commands via an RS-232, USB, or Ethernet connection, use the Extron
DataViewer utility or a control system to send and receive SIS commands. The table below lists a selection of SIS commands. For
a full list of SIS commands and variables, see the DTP2 CrossPoint 82 User Guide at www.extron.com.
Command
Input Selection
Select audio and video input
Select video input only (applies to
scaled DTP2 output only)
Select audio input only (applies to
scaled DTP2 output only)
Auto-Image
Execute Auto-Image™
Execute Auto-Image and fill
Execute Auto-Image and follow
Loop Out Input Selection
Set loop out input
View loop out input
KEY:
X!
= Input selection
X@
= Output selection
figure
ASCII Command
Response
InX!*X@ • All]
X!*X@!
InX! • 2 • Vid]
X!*2%
InX! •2• Aud]
X!*2$
1*0A
Img*0]
1*1A
Img*1]
1*2A
Img*2]
}
E X!
LoutX!
LOUT
}
]
E LOUT
X!
1
8
9
through
,
(Aux audio, selectable for scaled DTP2 output only)
1
= matrix output 1 (HDMI/DVI)
A
2,
, on
Additional Description
Select audio and video from input
Select the video only from input
Select the audio only from input
Execute an Auto-Image (follows aspect ratio setting).
Execute an Auto-Image and fill the output raster.
Execute an Auto-Image and follow the input aspect ratio.
]
Tie the loop output to input
View the loop out input. Default =
2
= scaled output 2 (DTP2/XTP/HDBT)
X!
X@
to output
.
2
X!
to output
.
2
X!
to output
.
X!.
1
5
Advertisement
