Advertisement
5. With help of an assistant, slide rear roof
front roof
together, compressing foam seal
Align mounting holes and install eight screws
with washers
as shown. Torque to specification.
9
TORQUE
20-24 in-lbs. (2.3-2.7 Nm)
6. If needed, clean lower edges of roof panels at
locations where foam seals from kit
installed. Install foam seals along panel edges as
shown.
and
.
will be
1
Instr 9925231
Rev 03 07/15
7. Install four U-clip nuts
pillars. Ensure nuts are oriented as shown.
8. With help of an assistant, place combined roof
assembly on top of vehicle ROPS so that front
retaining hooks engage slots in upper mount plate,
and middle retaining hooks are on forward side of
ROPS cross-member as shown.
9. With help of an assistant, slide roof assembly
rearward until all retaining hooks are fully seated in
vehicle ROPS as shown.
Page 3 of 4
into front roof mounting
Advertisement
