Siemens SIMATIC S5 Manual page 243

IP 265
D Keyboard Layout for COM 265 Editing Functions
on the Programmer
The COM 265 editing functions on the programmer are all invoked via the programmer's numeric
keypad. Nonetheless, a number of editing functions can also be invoked via other keys or key
combinations, as described in Section 8.5.4.
The information on the following pages describes how to initiate all COM 265 editing functions on
the programmer.
Inserting comments
Shift
+
Cursor control
Shift
+
EWA 4NEB 812 6130-02a
Keyboard Layout for COM 265 Editing Functions on the Programmer
: - Press <Shift> <5> once only
5
to enter the segment name
- Press <Shift> <5> twice in succession
to enter segment comments
: Move cursor up one line in an input field;
8
Move cursor up on a grid-oriented basis in a control system
flowchart
: Move cursor down one line in an input field;
2
Move cursor down on a grid-oriented basis in a control
system flowchart
: Move cursor one character to the left in an input field;
Move cursor to the left on a grid-oriented basis in a control
4
system flowchart
: Move cursor one character to the right in an input field;
6
Move cursor to the right on a grid-oriented basis in a
control system flowchart
: Move cursor to the next input field;
Tab
Move cursor from input bar to output bar in a control
system flowchart
: Move cursor to the preceding input field;
Tab Move cursor from output bar to input bar in a control
system flowchart
D-1