Siemens SIMATIC S5 Manual page 145

Programming the IP 265 with COM 265
Entering operand commentary for connectors:
Immediately upon completing a connector entry, and whenever the cursor is positioned to a
connector in a control system flowchart, an assignment line is displayed beneath the header
( Point ).
If you press the <CORR> key in Input mode, the cursor jumps from the current input field to
the assignment line.
This allows you to enter a commentary (max. 40 characters for the connector symbol ("KON1"),
e.g. "Valve closes".
You can confirm your entry or modify the commentary with <1> or <INSERT>, or exit the
assignment line without changing the original contents with < ESC>.
Modifying symbolic identifiers and operand commentary on the assignment line
Whenever you move the cursor to a symbolic identifier in a control system flowchart, the line from
the IP 265 assignment list for that operand is displayed immediately below the "Editor" form's
header.
"Editor" form
IP265 program: IP265
I 0.1 B6
-B6
????????
????????
The IP265 program utilizes approx. 4% of the IP265's capacity
F1 F2
Insert
& >=1
9-40
Segment: 1 of 1
&
F3
F4 F5
---0 S/R..
Figure 9-13. "Editor" Form; Enter Assignment Line
DI BERO 6
F6 F7 F8
T
CU/D >=<
IP 265
Assign-
ment
line
????????
F9 F10
# Special
EWA 4NEB 812 6130-02a