Siemens SIMATIC S5 Manual page 239

Technical Specifications
Digital 24 V outputs
Number of outputs
Galvanic isolation
Status indicators
Short-circuit protection
Load voltage L+
- Nominal value
- permissible range
Output current at "1" signal
Permissible total current of the outputs
Parallel switching of the outputs
Output frequency in the case of resistive load max. 1 kHz
Cable length
Lamp load
Residual current at "0" signal
Voltage drop with "1" signal
Voltage induced on circuit interruption limited to
Output circuit delay
- rising edge
- falling edge
dependent on resistive load:
Expansion inputs and outputs
Number of inputs and outputs
Connector for 24 V load voltage
Permissible cable cross-sections
- Flexible H07V-K cable with connector sleeve
- Solid H07V-U cable
*
Peak value (not an r.m.s specification)
Note
The IP 265 can be used in the S5-90U, S5-95U, S5-100U (CPU 100 from 6ES5 100-
8MA02, CPU 102 from 6ES5 102-8MA02 or CPU 103) and the ET 200U (IM 318-B from
Version 2).
B-2
9-pin sub D socket
8
no
yes, on 5 V side
yes, electronically clocked
24 V DC
20 to 30 V
0.5 A at 60 °C
2 A at 60 °C
possible in pairs (I
at 15 mA load
max. 2 kHz at 50 mA load
max. 4 kHz at 500 mA load
max. 100 m
max. 2 W
max. 1 mA
max. 1 V
- 15 V
typ. 10 µs
150 µs at
typ. 15 mA load
typ. 90 µs at 50 mA load
typ. 70 µs at 500 mA load
15-pin sub D HD socket
8 (any mix of I/Os configurable)
2-pin
2
0.5 to 1.5 mm
2
0.5 to 2.5 mm
IP 265
×0.8×I )
Outp Nom
*
*
*
*
*
*
EWA 4NEB 812 6130-02a