Siemens SIMATIC S5 Manual page 12

Ip 265 high speed sub control
Hide thumbs Also See for SIMATIC S5:
Table of Contents

Advertisement

IP 265
Conventions
This manual is organized in menu form to make it easier for you to find information. This means the
following:
Each section is marked with printed tabs.
On the next two pages of the manual, you will find an overview page that lists the title of each
section.
The overview page is followed by the detailed table of contents.
The detailed table of contents in turn preceeds every section.
Each section has three level headings that are numbered. The fourth level heading is not
numbered but appears in boldface type.
Pages, figures and tables are numbered separately for each section. On the back of the detailed
table of contents for each section, you will find a list of the figures and tables that appear in that
section.
The manual employs the following specific structuring devices:
Specific terms have characteristic abbreviations.
Example: programmer (PG)
Footnotes are marked with a raised asterisk "* ". You will find the corresponding explanations in
the lower margin of the page or below the table.
Lists are designated with bullets (•) (as in this particular listing) or dashes (-), or they are
numbered consecutively ( ).
Operator actions are indicated by a black triangle ( ).
Cross-references are indicated as follows:
"( Section 7.3.2)".
There are no references to specific page numbers.
Dimensions in drawings are indicated in "mm".
Value ranges are indicated as follows: 17 to 21
Expecially important information appears in framed boxes such as the following:
Note
You will find definitions of the terms "Warning" and "Note" in the next section, "Safety-Related
Guidelines for the User".
EWA 4NEB 812 6130-02a
Introduction
xv

Advertisement

Table of Contents
loading

Table of Contents