Troubleshooting; Setting Option Setup Method - Samsung AM017HN1DEH/EU Service Manual

Troubleshooting

4-3 Troubleshooting

4-3-1 Setting Option Setup Method

4-3-1-1 PCB option code input method
Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the
same time.You need to set twice when setting indoor unit address and installation option.
■ The procedure of setting option
Entering mode for
setting option
High Temp Button
Low Temp Button
Entering mode to set option
Step 1
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button
3. Check if you have entered the option setting status.
The procedure of option setting
Step 2
After entering the option setting status, select the option as listed below.
• The total number of available options are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page options used by the previous remote control models, the modes to set values
for these options are skipped automatically.
• Set a 2-digit value for each option pair in the followinig order: SEG2 and SEG3 SEG4 and SEG5 SEG6 and SEG8 SEG9 and
SEG10 SEG11 and SEG12 SEG14 and SEG15 SEG16 and SEG17 SEG18 and SEG20 SEG21 and SEG22 SEG23 and SEG24.
SEG1 SEG2 SEG3
0 X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X
280
Option setting mode
Mode change
High Fan Button
Low Fan Button
SEG4 SEG5 SEG6 SEG7 SEG8
X X X 1 X
X X X 3 X
Entering mode for
setting option
High Temp Button
Low Temp Button
SEG9 SEG10 SEG11 SEG12
X X X X
X X X X
Option setting mode
On(SEG1~12) Off(SEG13~24)
Samsung Electronics
Mode change
High Fan Button
Low Fan Button
.