Table of Contents
Advertisement
2
Installation (Getting Started)
42
3 Press <Menu>, choose Tx/Rx > Coupling then press
<Select>. Choose Copy Tx to Rx to set Coupling On. Select
Close to close dialog.
4 Press <Smart Test>, choose Shortcuts > Trouble Scan then
press <Select>. Press Run/Stop to begin a measurement.
5 Check that 'No Trouble' is displayed in the Results window
to confirm no errors have been detected. If not then refer to
"What to do if the Test fails" on page 45.
6 Press <Single Error> button and check that the Errors Led
flashes red and some errors accumulate on the Results -
Trouble Scan window. Then press the <Run/Stop> key to
stop gating.
7 Press <Window> key to highlight the Tx-Transmitter Settings
window and set the Laser to OFF.
Installation and Verification Manual
Advertisement
Table of Contents
