Drive For The Down-Cup Auger - Kemper 445 Operator's Manual

Scrapers on the Feed Drums
The scraper with the guide plate (A) can be turned in such
a way that it can be adjusted to the width of the feed roll
of the forage harvester. The rows of teeth on the drums
must run in the center of the scraper slot.
The distance (X) between the scraper and feed drum (B)
should not exceed 5 mm (0.2 in.).
A—Guide plate
B—Feed drum
The Bottom Feed Teeth on the Feed Drums
The maximum set distance of the deflector (A) to the top
of the feed teeth (B) is (X) 4 mm (0.16 in.).
A—Deflector
B—Feed teeth

Drive for the Down-cup Auger

The drive belt for the down-crop auger is located at the
outer end of the retractable mowing units. The guide of
the crosswise-mounted V-belt (A) is carried out by an
adjustable guide roller (B). The belt tension is adjusted by
pulling the rear, upper lift bearing upwards. The adjustment
procedure is explained on a sticker close to the drive belt.
A—V-belts
Service
X—5 mm (0.2 in.)
X—4 mm (0.16 in.)
B—Guide roll
55-12
KM00321,00008B0 -19-28JAN19-4/5
KM00321,00008B0 -19-28JAN19-5/5
KM00321,00008B1 -19-28JAN19-1/1
021519
PN=70