Delta Compact Drive MS300 IP66/NEMA 4X Series User Manual page 69

Recommended maximum wiring gauge when installing zero phase reactor
Model # of Zero
Phase Reactor
T600006L2040W453
T600006L2050W565
* Pass the zero phase reactor only through the power inputs (R/L1, S/L2, T/L3) or motor outputs (U/T1, V/T2, W/T3),
not the grounding PE.
Refer to the figures below for the common output wiring methods.
Zero Phase Reactor for Signal Cable
To solve interference problems between signal cables and electric devices, install a zero phase
reactor on signal cable. Install it on the signal cable which is the source of the interference to suppress
the noise for a better signal. The model names and dimensions are listed in the table below.
T60004L2016W620
T60004L2025W622
Chapter 7 Optional Accessories MS300 (IP66 / NEMA 4X)
Max. Wire Gauge
or LUG width
RF008X00A
Model
Max. Wire Gauge AWG*
75°C
13 mm 3 AWG
11 mm 6 AWG
16 mm 1 AWG
A B
10.7 17.8
17.5 27.3
7-19
90°C
1 AWG
6 AWG
1/0 AWG
Unit: mm
C
8.0
12.3