Delta Compact Drive MS300 IP66/NEMA 4X Series User Manual page 122

Chapter 10 Digital KeypadMS300 (IP66 / NEMA 4X)
Pr.13-00 = 2 specifies the Compressor application, and the keypad displays "CoPr".
Pr.13-00 = 3 specifies the Fan application, and the keypad displays "FAn".
Pr.13-00 = 4 specifies the Pump application, and the keypad displays "PUMP".
Pr.13-00 = 5 specifies the Conveyor application, and the keypad displays "CnYr".
Pr.13-00 = 6 specifies the Machine Tool application, and the keypad displays "CNC".
Pr.13-00 = 7 specifies the Packing application, and the keypad displays "PAC".
Pr.13-00 = 8 specifies the Textile application, and the keypad displays "tiLE".
When Pr.13-00 is not 0, the corresponding parameters appear in the APP page according to the
setting for Pr.13-00. In each selected application, you can view the parameters by pressing ENTER
button. If Pr.13-00 = 1 and you do not set any parameters in Pr.13-01–13-50, you cannot enter the
sub-layer of the USEr page. The parameter settings in the APP page are the same as those in other
parameter groups: use UP and LEFT/DOWN key to set the parameter's value.
Follow the process below to set the user-defined application selection (Pr.13-00 = 1).
Set Pr.13-00 = 1.
Activates user-defined
application selection.
To remove a user-defined
parameter, go back to
parameter group 13, and set the
parameter as 0.00 from the last
defined parameter in order.
Set Pr.13-01–13-50
user-defined parameters
in order.
To change a user-defined
parameter, go back to
parameter group 13 and
modify the value there.
10-4
When finishing setting, press
MODE button to display the APP
page, and then press ENTER to
display the USEr page. Press
ENTER again to display the
user-defined parameters.
Use UP and DOWN
key to select defined
parameters, and
press ENTER to
check the setting.