Table of Contents
Advertisement
Service Type
It is recommended to use the default settings.
3.2 DVB-T/T2 installation
Terrestrial Setting
Press ENTER to start directly searching for digital channels.
Optional you can search also for analogue channels.
Press p and select the Tune Type.
By pressing t u select DTV, ATV or DTV+ATV (DTV to search digital broadcasts and ATV to search
analogue broadcasts).
3.3 DVB-C installation
Cable Setting
Press pq t u to highlight your settings.
Scan type
Network ID
Frequency
Symbol Rate
Optional you can search also for analogue channels.
Press p select the Tune Type.
By pressing t u select DTV, ATV or DTV+ATV (DTV to search digital broadcasts and ATV to search
analogue broadcasts).
NOTE:
Press ENTER to start searching for digital channels.
4.0 ELECTRONIC PROGRAMME GUIDE (EPG)
EPG stands for Digital Electronic Programme Guide. It is supplied by the programme providers and offers
information on broadcasted programmes. You can access it in digital mode by pressing EPG on the
remote control. Press EPG to bring up the EPG interface. Use pq to select a channel.
Press u to switch to overview from one channel EPG. Use DOWN/UP to select event where you like to
know more details. These details are displayed on top of this EPG banner or press INFO button for full
screen. Press EXIT to stop and return to viewing modes.
Then press the COLOUR BUTTONS for entering the required settings.
8
Select All to search DTV channels and Radio. Select RADIO to search radio
channels only or DTV for only Digital TV channels.
You can select Network Scan, Blind scan or Full.
The default setting is Auto. To enter your own value press t u and enter
(with 0 ~ 9) the used Network ID from your provider.
The default setting is Auto. To enter your own value press t u and enter
(with 0 ~ 9) the main frequency used by your provider in KHz.
The default setting is Auto. To enter your own value press t u and enter
(with 0 ~ 9) the used Symbol Rate from your provider. (Ks/s) most used values
are 6900 or 6875.
Please, check the settings for your cable system used by your provider! Full
scan will have a duration of approximately 20 minutes, depending on your
cable network.
Advertisement
Table of Contents
