Table of Contents
Advertisement
User Manual - PolyGard
Multi-Gas-Controller MGC2-K Honeywell
3 Installation
Electronics can be destroyed by electrostatic discharge (ESD). Therefore, the installation work
should be done only by persons connected to ground, e. g. with a wrist strap connected to ground
or by standing on a conductive floor (acc. to DIN EN 100015).
3.1 Mounting Instructions
When choosing the mounting site please pay attention to the following:
•
Choose mounting location of the sensor according to the local regulations.
•
Mount the sensor at a location with minimum vibration and minimum variation in temperature (avoid
direct sunlight).
•
Avoid locations where water, oil etc. may influence proper operation and where mechanical damage
might be possible.
•
Provide adequate space around the sensor for maintenance and calibration work.
•
Observe possible local instructions.
3.2 Installation Work
Assembly work must only be carried out under gas-free conditions.
Do not drill holes in the housing. Use only the providing know-outs.
•
Open housing cover.
•
Break out the required pre-embossed knockouts on the housing for cable glands and Sensor
Cartridge.
•
Cables are introduced from above.
•
The MGC2 Controller is fixed to the wall through the four marked mounting points at the back side of
the housing. These mounting points are accessible after opening the housing. See figure below.
•
The dimensions XX depend on the type and can be read on the back of the housing, it is115 mm.
•
The mounting points are covered by closing the cover at the end of the assembly.
•
Close the cover.
Installation of Controller:
®
PolyGard
is a registered trademark of MSR
Phone 0049(0)8531/9004-0
Fax: 0049(0)8531/9004-54
MSR-Electronic GmbH, Bgm.-Schoenbauer-Str. 13, D 94060 Pocking www:msr-electronic.de Made in Germany
®
2
XX
Page
5
GAMGC2-K_E_0320
Specification subject to change without notice
Advertisement
Table of Contents
