Patient Monitor B105/B125
Cleaning and disinfection overview
The following cleaning and disinfection information applies to devices, device
components, supplies, and accessories manufactured by GE.
The information provided in this chapter does not supersede any instructions for use
provided by the manufacturer or provided with a device, device component, supply,
or accessory.
For cleaning, disinfection, and care information for devices, device components,
supplies, and accessories made by manufacturers other than GE, see the applicable
instructions for use provided by the manufacturer.
Cleaning
Cleaning warnings
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
2110145-001
Before cleaning or disinfecting, disconnect the device from
the power supply.
Avoid using other chemicals than the ones described in this
manual as they may damage device surfaces, labels, or cause
equipment failures.
To prevent liquids from entering the monitor, do not tilt the
monitor.
If liquid has accidentally entered the system or its parts,
disconnect the power cord from the power supply and have
the equipment serviced by authorized service personnel.
Never immerse any part of the device, cables, or leadwires in
liquids or allow liquid to enter the interior of the device.
Do not autoclave any part of the system with steam (including
cables or leadwires) or sterilize with ethylene oxide.
Do not pour or spray any liquid directly on the device, cables,
or leadwires or permit fluid to seep into connections or
openings.
Cleaning and disinfecting
6
37