Table of Contents
Advertisement
PS Engineering Inc. ®
PAR200B Audio Selector Panel, COM radio Controller and Intercom System
Installation and Operator's Manual
2.11 Communications Antenna Installation Notes
2.11.1 Antenna Location
For best results while in Split Mode, we recommend that the one VHF communications antenna is located
on top of the aircraft while the other communications antenna is installed on the bottom. Any antenna relo-
cation must be accomplished in accordance with AC 43.13-2B, aircraft manufacturers' recommendations,
and other FAA-approved technical data.
WARNING
It is probable that radio interference will occur in the split mode when the frequencies of the two air-
craft radios are adjacent, and/or the antennas are physically close together. PS Engineering makes no
expressed or implied warranties regarding the suitability of the PAR200B in Split Mode.
200-228-0300
Page 2-11
October 2019
Advertisement
Table of Contents
Need help?
Do you have a question about the PAR200B and is the answer not in the manual?