Alarm Volume; Storing The Device When Not In Use; Troubleshooting - Silvercrest SURF 600 A1 User Manual And Service Information

Alarm volume

The volume of the alarm tone for waking up with the radio depends on the radio volume previously set.
The alarm tone starts quietly and gets gradually louder. The corresponding icon
flashes on the display (11). If the last radio volume set was level three or lower, the alarm tone will sound
at volume level three. This ensures that the alarm tone sounds at a minimum volume even if the radio
volume was previously set to very quiet.
You cannot adjust the volume for waking up with the buzzer. In this case the time between two sounds
decreases with increasing waking time. The corresponding icon
display (11).

Storing the device when not in use

If you intend on not using the radio alarm clock for a longer period of time, keep it in a cool, dry,
clean place. If you do not wish to use the device for a very long time, if applicable, remove the
back-up battery to avoid leakage.

Troubleshooting

The device will not switch on

Check whether the power cable is plugged into the socket.

Check whether the socket is supplying power.
No radio reception, poor radio reception

Unwind the cable antenna (10) fully and try to better adjust this for optimum reception.

Set the station correctly. Where necessary, start another search.
The time will not set automatically

Unwind the cable antenna (10) fully and try to better adjust this for optimum reception of the radio
signal.
The device is switched on but there is no sound

Check the volume setting.
The time has not been saved after a power cut

No back-up battery has been inserted.

The inserted back-up battery is empty and needs to be replaced.
SilverCrest SURF 600 A1
(20) or
(20) or (19) flashes on the
(19)
English - 39