Sleep Timer; Nap Timer; Setting The Alarm (Alarm) - Silvercrest SURQ 4 A1 Operating Instructions And Safety Instructions

10.6 SLEEP timer

The SLEEP timer function lets you set a time of between 5 and 120 minutes, after which the radio will
automatically switch into standby mode. The procedure is as follows:
•
While the device is powered on, press the [ /NAP] button (12). The number of minutes increases
every time you press the [ /NAP] button (12). You can select a value of 5, 10, 15, 30, 60, 90
or 120 minutes. The "SLP OFF" option disables the sleep timer.
•
If the SLEEP timer is active, the corresponding symbol [ ] (29) is shown on the display (1).
•
While the SLEEP timer is active, you can press the [ /NAP] button (12) once to check the
remaining time or several times to change it. The remaining time reads at the bottom of the display
(1).
•
After the set time has elapsed, the radio automatically switches to standby mode.

10.7 NAP timer

You can set a one-off NAP timer (alarm sound only). The alarm time can be selected in 1 minute
increments between 1 minute and 120 minutes:
•
In standby mode, press the [ /NAP] button (12) until the alarm time you want is shown on the
display (1). This allows you to change the settings in 5-minute intervals. After "120" (120
minutes), the "OFF" option appears. This option deactivates the NAP timer.
•
You can adjust the alarm time in 1 minute increments by pressing the [ ] (3) and [ ] (9) buttons.
•
If the NAP timer is active, the corresponding [NAP] symbol (28) is shown on the display (1).
•
Once the set time has expired, an alarm sounds; this can be switched off by pressing any button.
The alarm volume starts very low and gets louder until the maximum volume is reached.
While the NAP timer is active, you can disable the NAP timer by pressing the
[ /NAP] button (12).

10.8 Setting the alarm (Alarm)

You can set up to two alarm times (alarm 1 and alarm 2). You can select an alarm tone or the radio
station last played for both alarms. Use the [
for alarm 2. Check that the clock is displaying the correct time.
] button (5) for alarm 1 and the [
SilverCrest SURQ 4 A1
] button (6)
English - 19