Connecting The Dut And Ate To The 'I/O Connector Module - Equinox Systems ISPnano IV-ATE Series Hardware User Manual

4.3 Connecting the DUT and ATE to the 'I/O Connector Module'

The instructions below detail how to connect the 'Target System' and external ATE / ICT equipment
to the 'I/O Connector Module'.
Instructions:
•
Connect the 'Target System' (UUT) to the 16-way 'Target ISP Port'.
•
Connect the external 'ATE System' or other control system to the 'ATE ISP Port'.
•
If you plan to remote control the programmer, connect the relevant remote control signals to
the 'Remote Control Port'.
The signal routing depends on whether the relays are energised (ON) or de-energised (OFF) – see
table below.
Relays
Relay
ON
position
Indicator
OFF OFF
(default)
ON ON
14
'Target ISP Port' signals are routed to the 'ATE ISP Port'
'Target ISP Port' signals are routed to the 'Internal Programmer
Power and I/O Driver Circuitry'
ISPnano Series IV-ATE Programmer - User Manual – V1.04 – 21/02/2014
Signal routing