Power Supply Requirements; Overview - Equinox Systems ISPnano IV-ATE Series Hardware User Manual

3.0 Power Supply requirements

3.1 Overview

The 'ISPnano Series IV ATE' programmer only requires a single power supply which is used to
power both the 'programmer electronics / Target System' and the 'relay coils'.
Please refer to the table below for the details of the power supply requirements.
Designator
(1) DC IN
(2) EXT IN
ISPnano Series IV-ATE Programmer - User Manual - V1.04 – 21/02/2014
Description
DC Input to power the programmer
•
Powers programmer internal
electronics
•
Also Powers 'Target System' (UUT) if
'Programmer controlled Power
Supply' is enabled.
External switched DC supply
An optional external power supply can be be
switched via the programmer using the
'EXT-IN' connector.
Voltage Current
range Requirement
(Volts) (mA)
9.0 – 24.0 150mA
minimum
(depends on
Target
System
current)
1.8 – 24.0 300 mA
9