Front Panel Layout - Equinox Systems ISPnano IV-ATE Series Hardware User Manual

1.2 Front panel layout

The layout of the front panel of the programmer is shown below.
# Connector Name
1 DC Power Input
2 EXTERNAL TARGET VCC
INPUT
3 Programmer STATUS LEDs Programmer 'Status' LEDs
4 RS485 Ports
5 USB Port
6 RS232 Port
or
Remote Display Keypad
Port
4
Description / comment
DC Power Input to power the programmer
•
Voltage range: 9.0 – 24.0 V DC (right-hand pin positive)
EXTERNAL TARGET VCC INPUT
•
DC Power Input to power relay coils
•
PASS (GREEN), BUSY (YELLOW), FAIL (RED)
RS485 Ports (1) + (2) - Serial Communications Ports
•
These ports can be used to control the programmer via an
RS485 link from a PC.
•
Up to 32 x ISPnano programmers can be connected on the
RS485 bus.
•
The connectors are connected in parallel internally so it does
not matter which is used as the RS485 INPUT or OUTPUT.
•
The connector is a 5-pin 2.54mm Molex.
High-speed USB Port
•
This port can be used to control the programmer via a USB
link from a PC.
RS232 Port - Serial Communications Port
•
This port can be used to control the programmer via an
RS232 link from a PC or other Test Equipment.
•
A 'Remote Display / Keypad Module' can also be
connected to this port allowing the programmer to be remote
controlled.
•
The connector is a 4-pin RJ11 connector.
ISPnano Series IV-ATE Programmer - User Manual – V1.04 – 21/02/2014