Hardware Setup; Powering The Programmer - Equinox Systems ISPnano IV-ATE Series Hardware User Manual

2.3 Hardware setup

The hardware setup instructions for the 'ISPnano Series IV ATE' programmer are detailed below.

2.3.1 Powering the programmer

Connect a suitable power supply to the 'DC-IN' connector of the programmer
 This powers the 'Programmer internal electronics'
Programmer Power Supply
+9.0V to +24.0V @ 150mA
min
You may use the 'Mains DC power supply' which comes as part of the kit or you can use your own
external power supply.
ISPnano Series IV-ATE Programmer - User Manual - V1.04 – 21/02/2014 7