1.1 Main Features
Features
•
Integrated 'ISPnano Series IV ATE' programmer (see separate features for this module)
•
Compact enclosure featuring integrated programmer and interchangeable 'I/O Connection
Module'
•
All programmer I/O signal lines are isolated from both the Target System (DUT) and external
test equipment e.g. ATE / ICT via relays
•
All power lines (Target Vcc, Target Vpp and GROUND) are independently switched via relays.
•
The ATE / ICT is routed to the Target System (UUT) by default so the programmer is
completely isolated from the UUT.
•
When a programming operation starts, the Target System (DUT) ISP I/O and power signals
are automatically switched to the programmer and the ATE / ICT is then completely isolated
from the programmer.
•
At the end of a programming operation, the Target System (DUT) is automatically re-
connected to the ATE / ICT.
•
Simple integration with ATE / ICT as the programmer controls the relay switching
•
Supports signal routing of an external 'JTAG Boundary Scan Tester' via the ATE Port to the
Target System (UUT).
ISPnano Series IV-ATE Programmer - User Manual - V1.04 – 21/02/2014
3