Maintenance; Troubleshooting - U-Line Marsh H-1358 Setup Instructions

Tape dispenser
Table of Contents

Advertisement

Available languages

Available languages

NOTE: Little maintenance is required, but
regular cleaning of the brush, brush tank,
cutter mechanism and tape path are
important. Clean the tape dispenser when the
water bottle needs refilling.
CAUTION! For units with power switch or heater:
before performing any maintenance or
repair procedures, turn off power switch and
disconnect from power source.
CLEANING WATER FEED SYSTEM
1. Clean the brush by soaking in warm, soapy water.
Rinse with warm water.
2. Clean the brush tank by rinsing in warm water.
3. Rinse out the water bottle and duckbill valve with
warm water.
CLEANING CUTTER ASSEMBLY
1. Open top cover and remove pressure plate.
2. Remove tape from tape path.
3. Using a small amount of non-flammable lubricant,
spray the cutter assembly behind the cutter guard
through the gaps in front and behind the cutter
guard.
4. Place tape back in tape path and place pressure
plate back into the machine.
CAUTION! For units with power switch or heater: before performing any
maintenance or repair procedures, turn off power switch and disconnect
from power source.
PROBLEM
Tape is jamming,
rearing or won't feed.
PAGE 4 OF 15

MAINTENANCE

TROUBLESHOOTING

CAUSE
Debris is in the tape path.
Tape guides are too tight.
Tape is routed incorrectly.
Pressure plate is out of the place.
Too much weight on the brush.
Cutter is not cutting tape.
CLEANING TAPE PATH
1. Open top cover and remove pressure plate.
2. Remove tape from tape path.
3. Using compressed air, remove all debris from the
tape path.
4. To remove gum adhesive buildup, use a moist cloth
to wipe down all sheet metal parts within tape
path. This includes the tape channel, pressure plate,
weighted brush tank cover and water tank holder.
5. Place the tape back into the tape path and place
the pressure plate back in the machine.
6. Close the top cover.
SOLUTION
Clean the tape path.
Adjust the tape guides with the tape guide
turnbuckle.
Reroute the tape.
Verify the pressure plate is in place.
Adjust the amount of weight on the brush.
Clean the cutter assembly. If problem
persists, contact Uline Customer Service
at 1-800-295-5510.
0915 IH-1358

Advertisement

Table of Contents
loading

This manual is also suitable for:

Marsh h-1359

Table of Contents