Troubleshooting; Preventive Maintenance - U-Line H-4404 Manual

When problems occur, carry out the following procedures. If the tape dispenser does not operate normally after
following the troubleshooting procedures, contact your supplier.
OPERATING ISSUE
Motor does not drive.
Tape does not cut.
LED does not light.
Tape does not feed.
Auto feed does not work.
Tape feeding does not
stop.
• Weekly – Remove cutting head and clean, and look
for missing roller rings. Replace as needed.
PAGE 5 OF 15

TROUBLESHOOTING

Check that the power cord is plugged in.
Check that the power switch is turned on.
Make sure the cutter unit is set properly and clean.
Check that the power cord is plugged in.
Check that the power switch is turned on.
Check if the tape is jammed at the roller or in the cutter
unit.
Check that the tape is set properly.
Check that the sensor plug is plugged in.
Check that the sensor switch of cutter unit is on.
Check that the sensor part of the cutter unit is not stained.
Check that the tape is centered. If not, set the tape at the
center of the feed roller so that the sensor will see the tape.

PREVENTIVE MAINTENANCE

1-800-295-5510
uline.ca
RECOMMENDATIONS
• Monthly–Remove blade spring and blades to inspect
cutter liners. Place one drop of silicone oil on each
liner, or replace if worn. Inspect feed roller and blade
for tape fragments or adhesive buildup. Clean with
alcohol.
0522 IH-4404