U-Line Marsh H-1358 Setup Instructions page 2

4. Feed the tape, gummed side down, over the top
roller, under the tape guide flaps, and under the
pinch roller. (See Figure 2)
Pinch
Roller
Shaft
Cutter
Assembly
FILLING WATER BOTTLE
1. Remove the water bottle from the dispenser.
(See Figure 3)
2. Remove the duckbill valve from the water
bottle. Fill the water bottle with water.
(See Figure 3)
3. Place the duckbill valve back into the water
bottle.
4. Place the water bottle back onto the
dispenser.
5. Verify that the post in the brush tank is inserted
through the duckbill valve.
PAGE 2 OF 15
SET-UP INSTRUCTIONS CONTINUED
Pinch Pressure
Roller Plate
Water
Bottle
Brackets
5. Place the pressure plate over the tape and release
the pinch roller. (See Figure 2)
6. Close the top cover.
Top Roller
Gummed
Side of Tape
Post
Figure 2
Tape
Tape Roll
Figure 3
Water
Bottle
Duckbill
Valve
Brush
Tank
0915 IH-1358
Tape
Weight