Ct3 Interface - Nortel Secure Router 3120 Installation Manual

54 CONFIGURATION
SR/configure/module/e1 (2/2)> exit 3
To provide E1 unframed and operate at 2048Mbps, you must disable
framing on the E1 interface:
SR/configure/module/e1 2/1 > framing disable
SR/configure/interface/bundle wan > show int bundle wan
bundle wan
----------
status down, ipcp not in open state
number of links 1
total bandwidth 2048 kbps
link speed bw inverted status diffdelay(msec)
---- ----- -- -------- ------ ----------------
e1 2/1:unchannelised 64 2048 no up -
T1 Interface
SR> configure term
SR/configure> module t1 1/4
SR/configure/module/t1 (1/4)> clock_source line
SR/configure/module/t1 (1/4)> framing esf
SR/configure/module/t1 (1/4)> linecode b8zs
SR/configure/module/t1 (1/4)> yellow_alarm gen_det
SR/configure/module/t1 (1/4)> exit 3
DS3 Interface
SR> configure term
SR/configure> module t3 1/1
SR/configure/module/t3 (1/1)> framing m13
SR/configure/module/t3 (1/1)> clock_source line
SR/configure/module/t3 (1/1)> mode 1
SR/configure/module/t3 (1/1)> scramble
SR/configure/module/t3 (1/1)> exit 3

CT3 Interface

SR> configure term
SR/configure> module ct3 1/1/1-5
SR/configure/module/ct3 (1/1/1-5)> framing c_bit
SR/configure/module/ct3 (1/1/1-5)> clock_source internal
SR/configure/module/ct3 (1/1/1-5)> exit 3
Copyright © 2005-2007, Nortel Networks
.
Note: The Secure Router 3120 supports G.703 for 2Mbps on E1
interface at 120 ohm UTP.
Secure Router 3120
Installation Guide
NN47260-300 02.01 Standard
9.2 10 January 2007
Nortel Networks Confidential