TRONXY X3A Operating	 Instruction
Hide thumbs Also See for X3A:

Advertisement

Tronxy 3D Printer
X3A
Operating Instruction

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the X3A and is the answer not in the manual?

Questions and answers

Summary of Contents for TRONXY X3A

  • Page 1 Tronxy 3D Printer Operating Instruction...
  • Page 2 Preparatory Work Turn on the power after micro SD card insert, then you can control the machine using key-press and the LCD display, as picture below: Micro SD card slot is at the back of the Plug in adaptor after Micro electronic box, near the USB Interfaces.
  • Page 3 Loading & Unloading PLA Loading PLA : 1, Press menu button, Straighten select ‘Prepare’-‘Preheat one end of PLA’, then Right key to confirm. filament 2, Take the filament and then straighten one end after Temp. up to 190 degrees. 3, Press the extrution clip , feed the filament Feed the into the hole.
  • Page 4 Off-line Printing Operate the printer with the key-press and LCD screen after print bed is leveled, as shown below: You will see the ‘monitoring interface’ first after power on Press menu button go into ‘menu screen’. Press Down key after into menu, then you will see ‘Print from SD’...

Table of Contents