H2Tu-C-319 List 4E Adc Config Menu Options - ADC HiGain H2TU-C-319 List 4E User Manual

LTPH-UM-1049-02, Issue 2
Table 5. H2TU-C-319 List 4E Standard Config Menu Options (Continued)
Front-Panel
Standard Config
Display
Menu Options
Code
Power Back Off PBOC
Customer
Front-Panel
ADC Config Menu
Display
Options
Code
Line Power Feed PWRF
Remote Provisioning RTPV
Bipolar Violation BPVT
Transparency
See "Bipolar
Violation
Transparency
(BPVT) Option" on
page 22.
DS1 BER Threshold DBER
See "DS1 BER
(DBER) Option" on
page 22.
HDSL2 BER HBER
Threshold
See "HDSL2 BER
Threshold (HBER)
Option" on page 22
and "System Alarm
Output Pin" on
page 70.
Special Loopback SPLB
Mode
SmartJack Loopback LPBK
H2TU-C-319 List 4E
Selection Description
DEF Configures the power output levels of the H2TU-R network unit towards the
network to comply with the Default template as defined in Section 6.1.4.2 of
ANSIT1.E1.4.
ENH Configures the power output levels of the H2TU-R network unit towards the
network to comply with the Enhanced template as defined in Section 6.1.4.2
of ANSIT1.E1.4.
Table 6. H2TU-C-319 List 4E ADC Config Menu Options
Selection Description
OFF Disables powering to the HDSL2 pair.
ON Keeps the HDSL2 line voltage at nominal -185 Vdc.
ENA Enables remote provisioning.
DIS Disables remote provisioning.
ENA Enables BPVs and HDSL2 CRC errors at the DS1 input to be converted into
DS1 BPVs at the DS1 output at the distant end. This makes HiGain HDSL2
transparent to BPVs.
DIS Disables BPV Transparency.
ENA Enables the fixed 24-hour DS1 BER threshold.
DIS Prevents the generation of a system alarm due to DS1 BER.
1E-6 System alarm relay contact closes and the Status LED flashes red when the
Block Error Rate (BER) exceeds 10
1E-7 System alarm relay contact closes and the Status LED flashes red when BER
exceeds 10
NONE Prevents generation of a system alarm due to BER.
GNLB Configures the HiGain HDSL2 system to respond to the generic in-band
loopback codes.
A2LB Configures the HiGain HDSL2 system to respond to the in-band loopback
codes of the Teltrend addressable repeater.
A3LB Configures the HiGain HDSL2 system to respond to the in-band loopback
codes of the Wescom addressable repeater.
A4LB Configures the HiGain HDSL2 system to respond to the in-band loopback
codes of the Wescom Mod 1 addressable repeater.
ENA Enables the HiGain HDSL2 system to recognize all in-band SmartJack
loopback commands.
DIS Configures the HiGain HDSL2 system to ignore all in-band SmartJack
loopback commands.
January 9, 2002
-6
.
-7
.
Provisioning
Continued
19