ADC HiGain H2TU-C-319 List 4E Quick Installation
  1. Manuals
  2. Brands
  3. ADC Manuals
  4. Network Hardware
  5. HiGain H2TU-C-319 List 4E
  6. Quick installation

ADC HiGain H2TU-C-319 List 4E Quick Installation

Line unit
Hide thumbs Also See for HiGain H2TU-C-319 List 4E:
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
HiGain
HiGain
HiGain
HDSL2
L
4E
SETUP
M
O
D
E
STATUS
B
R
G
O
U
L
T
I
N
E
B
R
G
I
N
L
I
N
E
R
S
2
3
2
DCE
H
2
T
U
*
C
3
1
9
S
E
L
H2TU-C-319 L
L
Q
I
UICK
NSTALLATION
U
INE
NIT
4E
IST

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HiGain H2TU-C-319 List 4E and is the answer not in the manual?

Questions and answers

Related Manuals for ADC HiGain H2TU-C-319 List 4E

Summary of Contents for ADC HiGain H2TU-C-319 List 4E

  • Page 1 HiGain HiGain UICK NSTALLATION HiGain HDSL2 SETUP STATUS H2TU-C-319 L...
  • Page 2 H2TU-C-319 L The H2TU-C-319 List 4E functions as the Central Office (CO) end of a repeaterless T1 transmission system when connected to a HiGain HDSL2 remote unit (H2TU-R). Setting new standards for interoperability and efficiency, HiGain HDSL2 modules transmit a 1.554 Mbps T1 payload on one unconditioned copper pair over the full Carrier Service Area (CSA) range.
  • Page 3 Select the Inventory menu, then type in the unit ID numbers. Change the settings of any system parameters, if necessary, by selecting the Config menu, Standard Options or ADC Options. (Configuration options can also be set from the front panel using the MODE and SEL buttons. See the “Front-Panel...
  • Page 5 Loopdown 11100 Deactivates any of the above loopbacks. Copies of this publication or the technical practice (LTPH-UM-1049-xx) can be downloaded from the ADC website at www.adc.com. To order a hard copy, please contact your sales representative. Front-Panel Alarm Messages Message Description A short between the Tip and Ring of the HDSL2 pair.
  • Page 6 Front Panel Diagnostic Messages Message Description (normal operating messages in bold) A=xx The loop attenuation of the longest (maximum loss) span, measured in dB. The multiplexers of the H2TU-C and H2TU-R are trying to establish synchronization. Armed to respond to Intelligent Repeater Loop (ILR) codes. BAD RT? The H2TU-C is not receiving a response from the H2TU-R.
  • Page 7 © 2002 ADC DSL Systems, Inc. All rights reserved. Information contained in this document is company private to ADC DSL Systems, Inc., and shall not be modified, used, copied, reproduced or disclosed in whole or in part without the written consent of ADC.

Table of Contents