Higain Line Unit List 1 Adc Config Screen Options - ADC HiGain H2TU-C-388 User Manual

Provisioning
Table 5. HiGain Line Unit List 1 Standard Config Screen Options (Continued)
Screen
Standard Config
Display
Screen Options
Code
H2TU-R TLOS TLOS
Loopback
Network NLBP
Loopback Pattern
ADC Config Screen Screen
Options Display Code
Line Power Feed PWRF
Remote Provisioning RTPV
Bipolar Violation BPVT
Transparency
See "Bipolar
Violation
Transparency
(BPVT) Option" on
page 19.
DS1 BER Threshold DBER
HDSL2 BER HBER
Threshold
See "HDSL2 BER
Threshold (HBER)
Option" on page 19.
Special Loopback SPLB
Mode
SmartJack Loopback LPBK
18
Selection Description
ENA Enables a logic loopback at the H2TU-R when an LOS occurs at its DS1 input.
See Figure 25 on page 38
DIS Disables TLOS logic loopback.
AIS Enables the H2TU-R to transmit AIS towards the CI for any network loopback.
See Figure 25 on page 38
LOS Enables the H2TU-R to transmit LOS towards the CI for any network loopback.
Table 6. HiGain Line Unit List 1 ADC Config Screen Options
Selection Description
OFF Disables powering to the HDSL2 pair.
ON Keeps the HDSL2 line voltage at nominal -185 Vdc.
ENA Enables remote provisioning.
DIS Disables remote provisioning.
ENA Enables BPVs and HDSL2 CRC errors at the DS1 input to be converted into
DS1 BPVs at the DS1 output at the distant end. This makes HiGain
transparent to BPVs.
DIS Disables BPV Transparency.
ENA Enables the fixed 24-hour DS1 BER threshold.
DIS Prevents the generation of a system alarm due to DS1 BER.
1E-6 The Status LED flashes red when the Block Error Rate (BER) exceeds 10
1E-7 The Status LED flashes red when BER exceeds 10
NONE Prevents generation of a system alarm due to BER.
GNLB Configures the HiGain system to respond to the generic inband loopback
codes.
A1LB and Configures the HiGain system to respond to the inband loopback codes of
A2LB the Teltrend addressable repeater.
A3LB Configures the HiGain system to respond to the inband loopback codes of
the Wescom addressable repeater.
A4LB Configures the HiGain system to respond to the inband loopback codes of
the Wescom Mod 1 addressable repeater.
A5LB Configures the HiGain system to respond to the inband loopback codes of
the Teltrend Mod 1 addressable repeater.
ENA Enables the HiGain system to recognize all inband SmartJack (SMJK)
loopback commands.
DIS Configures the HiGain system to ignore all inband SmartJack loopback
commands.
for LOS/AIS response priorities.
for LOS/AIS response priorities.
June 6, 2000
152-388-100-02, Issue 2
-6
.
-7
.
Continued
H2TU-C-388 List 1