H2Tu-C-231 List 1F Adc Config Screen Options - ADC HIGAIN HDSL2 Manual

152-231-116-01, Revision 01
Table 5. H2TU-C-231 List 1F Standard Config Screen Options (Continued)
Screen
Standard Config
Display
Screen Options
Code
H2TU-R TLOS TLOS
Loopback
Network Loopback NLBP
Pattern
Power Back Off PBON
Network
See "Power Back Off
(PBON and PBOC)
Option" on page 22.
Power Back Off PBOC
Customer
See "Power Back Off
(PBON and PBOC)
Option" on page 22.
Screen
ADC Config Screen
Display
Options
Code
Line Power Feed PWRF
Bipolar Violation BPVT
Transparency
See "Bipolar Violation
Transparency (BPVT)
Option" on page 19.
DS1 BER DBER
See "DS1 BER (DBER)
Option" on page 20.
HDSL2 BER Threshold HBER
See "HDSL2 BER
Threshold (HBER)
Option." on page 19.
H2TU-C-231 List 1F
Selection Description
ENA Enables a logic loopback at the H2TU-R when an LOS occurs at its DS1 input,
if enabled at the H2TU-R. For priority resolution, see
DIS Disables Transmit Loss of Signal ((TLOS) logic loopback.
AIS Enables the H2TU-R to transmit an AIS towards CI for any network loopback.
For priority resolution, see
LOS Enables the H2TU-R to transmit an LOS towards CI for any network loopback.
DEF Configures the power output levels of the H2TU-C network unit towards the
customer to comply with the Default template as defined in Section 6.1.4.2 of
ANSIT1.E1.4.
ENH Configures the power output levels of the H2TU-C network unit towards the
customer to comply with the Enhanced template as defined in Section 6.1.4.2
of ANSIT1.E1.4.
DEF Configures the power output levels of the H2TU-R customer unit towards the
network to comply with the Default template as defined in Section 6.1.4.2 of
ANSIT1.E1.4.
ENH Configures the power output levels of the H2TU-R customer unit towards the
network to comply with the Enhanced template as defined in Section 6.1.4.2
of ANSIT1.E1.4.
Table 6. H2TU-C-231 List 1F ADC Config Screen Options
Selection Description
OFF Disables powering to the HDSL2 pair.
ON Keeps the HDSL2 line voltage at nominal -185 Vdc.
ENA Enables HDSL2 CRC and BPV errors at the DS1 input to be converted into
DS1 BPVs at the DS1 output at the distant end. This makes HiGain
transparent to BPVs.
DIS Disables BPV Transparency.
ENA Enables the fixed 24-hour DS1 BER threshold (10
DIS Prevents the generation of a system alarm due to DS1 BER.
1E-6 Front-panel alarm is displayed and the Status LED flashes red when the Block
Error Rate (BER) threshold exceeds 10
definition of Bit Error Rate.)
1E-7 Front-panel alarm is displayed and the Status LED flashes red when the BER
threshold exceeds 10
NONE Prevents generation of an alarm due to BER.
October 2, 2000
Figure 29 on page 48.
-6
-6
. (Block Error Rate is based on the
-7
.
Provisioning
Figure 29 on page 48.
).
Continued
17