Programming With Bootloader - mikroElektronika SmartGLCD User Manual

For programming, microcontroller use bootloader program which
is preinstaled in to MCU memory. To transfer .hex file from a PC
to MCU you need bootloader software (mikroBootloader) which
can be downloaded from:
http://www.mikroe.com/eng/products/view/443/
smartglcd-240x128-board/
After software is downloaded unzip it to desired location and
start mikroBootloader software.
Figure 3-1: mikroBootloader software
note
Connect SmartGLCD with a PC before
starting mikroBootloader software
Page 10