YILMAZ ACK 420 Manual page 41

8.2.4 Take the M10 screw (FIGURE 3 NO.43) outside by rotating in the direction of counter clockwise with 8mm
Allen switch. (Hold with 17 two-edged switch from the side in the saw axle of which switch edge is opened)
8.2.5 Remove the connection parts of cutting set in the right order.. (FIGURE 5 NO.39 / 41 / 42)
8.2.6 Remove the saw carefully
8.2.7 Mount the saw by being sure that the rotation direction onto the axle is true.(FIGURE 5 NO.40)
8.2.8 Replace all removed parts in the same order.
8.2.9 By holding the M10 Allen screw by 8mm Allen switch and the saw axle simultaneously by 17 switches tighten in
the direction of clockwise.
8.2.10 The saw selection should be made proper to EN 847-1 Standard.
In cases that the motor straps should be
changed, demand certainly by us technical
service dsupply.
41