Real Calibration (With Sample Weights); Analog Output Setting - LAUMAS TLU Installation And User Manual

40020 SETPOINT 2 L
40021 SETPOINT 3 H
40022 SETPOINT 3 L
40023 SETPOINT 4 H
40024 SETPOINT 4 L
40025 DELAY 1 H
40026 DELAY 1 L
40027 DELAY 2 H
40028 DELAY 2 L
40029 DELAY 3 H
40030 DELAY 3 L
40031 DELAY 4 H
40032 DELAY 4 L
40033 INPUT
40034 OUTPUT
40041 Sample weight for calibration H
40042 Sample weight for calibration L
Weight value corresponding to the
40043
ZERO of the analog output H
Weight value corresponding to the
40044
ZERO of the analog output L
Weight value corresponding to the
40045
Full Scale of analog output H
Weight value corresponding to the
40046
Full Scale of analog output L
At the moment of writing setpoint, delay values, the analog output zero and full scale values are
saved in RAM; they are lost upon shut down. To save them permanently in the EEPROM so that
they remain upon re-start, it is necessary to send the command 99 to the "Command Register".
The instrument calibration can be changed via MODBUS.
To carry out this procedure, the system must be unloaded and the weight value display reset to zero
with the command 100 of the "Command Register". Then, a sample weight must be placed on the
system, equal to at least 50% of the maximum capacity (in order to obtain greater accuracy) and the
correct weight value must be sent to the registers 40041-40042, to save this value, send the command
101 from the "Command Register". If the operation is successfully completed, the two sample weight
registers are set to zero.
Write the weight in the registers "Weight value corresponding to the Full Scale of analog output H"
(40045) and "Weight value corresponding to the Full Scale of analog output L" (40046) or write the

REAL CALIBRATION (WITH SAMPLE WEIGHTS)

ANALOG OUTPUT SETTING

"Command Register"
NO
Use with command 101
of the "Command
Register"
Only after
command '99'
of the
"Command Register"
- 31 -
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
- R
R
R/W
R/W
R/W
R/W
R/W
R/W