Setpoint Programming - LAUMAS TLU Installation And User Manual

From the weight display, press MENU to access the setpoint setting.
MENU/ENTER: to enter a menu/confirm the data entry.
▲: to modify the displayed figure or menu item.
◄: to select a new figure or modify the displayed menu item.
ESC: to cancel and return to the previous menu.
-  (from 0 to max full scale; default: 0): Setpoint; relay switching occurs when the weight
exceed the value set in this parameter.
- : (from 0 to max 9.9 s.; default 0) delay time between the moment when the weight exceeds
the set-point and the moment when the relay opens
- : for setpoint 1 only the possible values are:
 : the commutation of the relay comes about by either the positive or negative weight
value
 : the commutation of the relay comes about only by a positive weight value.
 : the commutation of the relay comes about only by a negative weight value.
These values are set to zero if the calibration is changed significantly (see sections
THEORETICAL CALIBRATION and REAL CALIBRATION (WITH SAMPLE WEIGHTS)).

SETPOINT PROGRAMMING

- 20 -